|
REAGENTS
Guanadinium Thiocyanate 1.0 M Sodium Citrate pH 7.0 10% Sarcosyl 2-mercaptoethanol water saturated phenol pH 4.0-7.0 Na2EDTA |
MOPS (free acid) 2.0 M Sodium Acetate pH 4.0 Formaldehyde Formamide 10% SDS 49:1 Chloroform:Isoamyl Alcohol |
SOLUTIONS
filter sterilize through 0.2 μm filter NOTE: Solution D may be made ahead of time and stored at room temp for one month,but the 2-mercaptoethanol must be added immediately before use.
PROTOCOL 1) Aspirate off media 2) Lyse cells in Solution D T-150 = 4 ml Solution D Transfer to pre-chilled 30 ml Oakridge centrifuge tube; make sure there is enough space for additions below. 3) Sequentially add: a) 0.1 volume 2.0 M NaOAc - mix well b) 1 volume phenol - mix well c) 0.2 volume chlorofom/isoamyl alcohol 4) Vortex 10 sec 5) Incubate on ice for 15 min 6) Centrifuge 10,000 x g, 20 min, 4 ℃ 7) Transfer aqueous phase to a new 50 ml conical 8) Precipitate with 1 volume isopropanol, %26gt;1 hour, -20 ℃ 9) Centrifuge in 50 ml conical tube, 3,000 x g, 1 hour, 44 ℃ alternatively, spin in oakridge tubes 10,000 x g, 20 min, 4 4 ℃ 10) Dissolve pellet in 0.3 ml Solution D; transfer to microfuge tube 11) Precipitate with 1 volume isopropanol, %26gt;1 hour, -20 4 ℃ 12) Centrifuge 15 min, 4 4 ℃ 13) Wash pellet with 75% ethanol 14) Dry*, dissolve in H2O**, heat to 65 4 ℃for 10 min to completely dissolve. *Do not over dry pellet, otherwise it will be impossible to dissolve **use approximately 150 μl H2O per T-150 flask
Chomczynske, P. and Sacchi, N. Analytical Biochem. 1987. 162:156-159
上一篇:Run-On Transcription 下一篇:Polymerase III in vitro Transcription
|